EAT LPS Dual Linear Power Supply

Elegant, Efficient, and Performance-Enhancing Ultra-Quiet Power Supply

The European Audio Team's LPS Linear Power Supply is an elegant, efficient, and performance-enhancing power supply for EAT phono preamps and turntables. EAT strongly believes that the power supply is a part of a component's signal path. Therefore, the quality of power supply extremely significantly contributes to the sound quality. Thus, the LPS Linear Power Supply is engineered without technical compromise.

The LPS provides full-bridge rectifying with ultra-fast diodes, followed by a huge 8800uF filtration bank. No op-amps are used in the circuitry, and the voltage reference is TL431. The result is very low noise and perfect regulation. In fact, in many respects the LPS outperforms battery power supplies. The ripple voltage is lower than 1 microvolt. Voltage accuracy is better than ± 0,05%. The temperature drift is beyond every level of standard power supplies. RFI is eliminated from the mains AC.

Two Power Supplies in One

The LPS is designed as two separate power supplies in one! Dual outputs allow you to connect an EAT turntable and preamp at the same time. Or connect two turntables and two electronic components, if you prefer. In addition to excelling with EAT gear, the LPS is compatible with select Pro-Ject electronics, too. (See "Features" tab for more information.)

Included with the LPS are three power cables for use between the LPS and the components you are powering. The cables are compatible with various EAT and Pro-Ject products.

Overview

• Ultra-clean outboard power supply for EAT
• Two separate power supplies in one
• Dual output simultaneously powers two EAT components
• RFI eliminated from mains
• Elegant appearance complements EAT gear
• Compatible with EAT turntables and phono preamps
• Also compatible with select Pro-Ject components (see below)

• 1 × 15V 2.1mm (for E.A.T. C-Sharp, EAT C-Major and all Pro-Ject turntables)
• 1 × 15V XLR 4Pin (for E.A.T. E-Flat, E.A.T. Forte S*)
• 1 × 18V 2.5mm (for E.A.T. E-Glo S, EAT Forte* and all Pro-Ject Phono products except Phono Box RS and AD Box S2 Phono)

• Input power supply 120V or 230V AC
• Output voltage / Current 1 × 15V/2A ± 0.05%, noise max. 10uV
• Output voltage / Current 1 × 18V/1.5A ± 0.05%, noise max 1uV
• Dimensions: 17.1" W × 2.4" H × 10.7" D
• Weight: 10.8 lbs.