AudioQuest Red River Interconnect Cable - 1.0 Meter - RCA to RCA - Pair

Red River Is the Rivers-Series Cable Built Around a Third Conductor

AudioQuest's Red River sits second in the Rivers series, above Chicago. It is a two-cable design, one lead per channel. Solid Perfect-Surface Copper, a dedicated ground wire and cold-welded gold plugs set it apart from the entry cables.

Solid Perfect-Surface Copper, Direction-Controlled

The wires are solid Perfect-Surface Copper, which AudioQuest calls PSC. AudioQuest draws the wire with a very smooth surface and says this cuts the distortion caused by grain boundaries. Solid wire also removes strand interaction.

The wire is also direction-controlled. AudioQuest says drawn wire has a grain with a direction. It listens to every batch, picks the direction, and marks the jacket with arrows. Point the arrows at the amplifier and noise drains where AudioQuest intends.

Hard-Cell Foam and Triple-Balanced Geometry

The insulation is Hard-Cell Foam, injected with nitrogen to form air pockets. AudioQuest says the stiff foam holds the signal pair in a fixed geometry along the whole cable. Air stores almost no signal energy, so little is released late as smear.

The layout is what AudioQuest calls Triple-Balanced. A third wire carries the ground on its own. The shield never has to double as a signal path. AudioQuest says both signal legs then travel equally clean routes.

The Cold-Welded, Gold-Plated Plug, Explained

Red River ends in AudioQuest's own gold-plated RCA plug. It is cold welded, not soldered. A press bonds the plug to the wire under high pressure. AudioQuest calls solder "a common source of distortion." The cold weld keeps the wire's character right up to the contact.

Around the cable is AudioQuest's Metal-Layer Noise-Dissipation. AudioQuest says an ordinary shield drains radio noise straight into the equipment's ground and pollutes the reference the signal is measured against. The metal layer absorbs the noise before it gets that far.

What Reviewers Are Saying

What Hi-Fi? reviewed Red River on May 13, 2014 and gave it four stars. Plugged into the magazine's reference system, "there's immediately a greater sense of space and dynamics compared with budget cables."

The verdict was plain about the trade. What Red River "lacks in smoothness and subtlety, it makes up for in scale and dynamic scope," the magazine wrote, calling its boldness the only real criticism.

Who Is This Interconnect Best For?

• You want scale and drive — What Hi-Fi? heard a broad soundstage and driving sound, so music fills the room
• Your left and right jacks sit far apart — Red River is two separate cables, so mono amplifiers and wide racks are no problem
• Your sources sit near power supplies — the separate ground wire and metal shield drain noise, so the shelf stays out of the music
• You want no solder in the path — AudioQuest cold welds the plug to the wire, so the joint is metal on metal
• You want the smoothest sound — What Hi-Fi? found Red River bold, at times forward. For refinement, step up to AudioQuest Mackenzie or call us

How Does It Connect to Your System?

Run Red River from a line-level output, a DAC, streamer, CD player or phono stage, to a line-level input on your amplifier or preamp. Point the arrows on the jacket toward the amplifier. Push each plug straight on until it seats. Pull it off by the barrel, never by the cable.

Then listen. Other and longer lengths available. Call for prices.

Pairs Well With

An interconnect is one link in the chain. It usually joins these categories.

• Integrated Amplifiers — the usual input end
• Digital-to-Analog Converters — DAC output to amplifier
• Phono Preamplifiers — phono stage to line input
• Speaker Cables — the last link to the speakers

Frequently Asked Questions

What is the cold-welded, gold-plated plug?

AudioQuest's own gold-plated RCA plug. It is joined to the wire by pressure, not solder. AudioQuest names solder as a common source of distortion.

What does Triple-Balanced mean?

The cable has three wires: positive, negative and a separate ground. AudioQuest says this keeps the shield out of the signal path, so both signal legs travel equally clean routes.

Which way do the arrows point?

Toward the component that receives the signal, normally the amplifier or preamp. AudioQuest sets the direction of the wire and says the arrows let noise drain the right way.

Is Red River sold as a pair or a single?

Both. Each channel is its own cable, so we list a stereo pair and a single for mono runs and center channels.

What warranty does AudioQuest give?

A limited lifetime warranty to the original owner, for cables bought from an authorized US dealer. AudioQuest will repair or replace a defective cable that has not been abused. Keep your proof of purchase.

Is there a step up?

AudioQuest Sydney is the next rung. It moves to Perfect-Surface Copper+, air-tube insulation, a carbon shield and silver-plated plugs.

Why Audio Advisor?

• 40+ Years of Expertise — Since 1981, we've helped over a million music lovers find the right gear.
• 60-Day Money-Back Guarantee — Take your time. Listen, enjoy, and make sure it's right for you.
• Real Experts, Real Help — Our team is here to answer your questions at 800-942-0220, weekdays 9am–6pm EST.
• Free Shipping — On orders over $49, delivered to your door.
• Flexible Payment Options — Financing available so you can start listening now.

Learn More

Want to learn more about interconnects, solid-core cables, or RCA versus XLR? Visit our Learning Center for guides, tips, and expert advice.