Cardas Audio Clear Headphone Cable for Sennheiser HD600 & HD650 Headphones - 3.0 Meter

Clear Headphone Cable, Built for Sennheiser HD600 and HD650

A headphone cable must physically match both ends of the chain: the connector on your headphones and the connector on your amplifier or DAC. Getting either wrong means the cable simply will not plug in, which is why the fit matters as much as the build quality.

Cardas Clear Headphone Cable is built specifically for Sennheiser HD600 and HD650 headphones, terminating in a Cardas 1/4" (6.35mm) stereo male plug at the amplifier end and the connector your HD600 or HD650 uses at the headphone end.

Grade 1, 99.9999% Pure Oxygen-Free Copper

Cardas builds Clear Headphone Cable around a dual mono run, two completely isolated cables for left and right, the same approach used in its speaker cables. The conductors are Matched Propagation Kevlar-core Litz wire, Grade 1, 99.9999% pure oxygen-free copper with SPN clear coat, gauge sizes scaled to Golden Ratio proportions, insulated in an FEP tape-wrapped jacket.

Dual Mono Geometry With a Suspended Shield

Cardas suspends a composite shield of 42 AWG tinned copper and magnet wire away from the signal conductors, carried on oversized PTFE air-tubes, then finishes the cable in an ultra-soft extruded TPR jacket. The gauge runs 8x26.5 AWG for an outside diameter of 0.170 inches, or 4.31mm.

The Connectors, Explained

This cable terminates in a Cardas 1/4" (6.35mm) stereo male plug at the amplifier end, and in the connector your Sennheiser HD600 or HD650 uses at the headphone end. It will not fit any other headphone.

Who Is This Headphone Cable Best For?

• You own a Sennheiser HD600 or HD650 — this cable is built specifically for that connector, not a universal fit forced to work
• Your amplifier or DAC has a standard 1/4" headphone output — the amp end is a Cardas 1/4" stereo male plug, the most common headphone jack size
• You want Cardas's dual mono construction, the same approach used in its speaker cables — Clear Headphone Cable scales that design down specifically for headphones
• You are replacing a stock or worn cable on a long-owned HD600/650 — Cardas describes exactly this kind of repeat replacement as the reason the line exists
• Your headphones are not a Sennheiser HD600 or HD650 — Cardas's other headphone-fit cables cover different models; check which connector your own headphones use before ordering

How Does It Connect to Your System?

Plug the Cardas 1/4" (6.35mm) stereo male plug end into the headphone output on your amplifier or DAC, and the other end into your Sennheiser HD600 or HD650.

Then power up the system as usual. Other and longer lengths available. Call for prices.

Pairs Well With

A headphone cable is one link between your headphones and an amplifier or DAC. It usually joins these categories.

• Headphone Amplifiers — the amp end of this cable plugs directly into one
• Headphones — the cable only helps once it's matched to the right pair
• Digital-to-Analog Converters — many desktop DACs include a headphone output this cable can feed
• Headphone Accessories — stands, cases and other gear for the same headphone this cable serves

Frequently Asked Questions

What is the amp-end plug made of?

Cardas machines its own GRQ-series 1/4" plug from eutectic brass and plates it rhodium over silver, a non-magnetic combination Cardas says keeps the contact clean for years. The cable itself carries a Cardas lifetime warranty against bad or intermittent internal connections, shorts, and loose connectors.

Does this cable work with both HD600 and HD650?

Yes. Cardas builds this cable for both models, which share the same headphone-end connector.

Is the amp-end plug balanced or single-ended?

Single-ended. The amp end is a standard Cardas 1/4" (6.35mm) stereo male plug, not a balanced XLR plug.

What does dual mono construction mean here?

Cardas runs two completely isolated cables, one for the left channel and one for the right, rather than sharing a single jacketed cable for both. It's the same geometry Cardas uses in its speaker cables, scaled down for headphone use.

Is there a step up?

Cardas's HD800 version of this same cable uses the same Clear Headphone Cable construction, built instead for the HD800's own connector.

Why Audio Advisor?

• 40+ Years of Expertise — Since 1981, we've helped over a million music lovers find the right gear.
• 60-Day Money-Back Guarantee — Take your time. Listen, enjoy, and make sure it's right for you.
• Real Experts, Real Help — Our team is here to answer your questions at 800-942-0220, weekdays 9am–6pm EST.
• Free Shipping — On orders over $49, delivered to your door.
• Flexible Payment Options — Financing available so you can start listening now.

Learn More

Want to learn more about headphone cables, headphone amplifiers, or system setup? Visit our Learning Center for guides, tips, and expert advice.