Kimber Kable Hero Interconnect Cable - 4.0 Meter - WBT 102 Cu RCA's - Pair

Hero Is Kimber's Four-Wire Braid

Kimber Kable's Hero is the interconnect Kimber built around four conductors instead of three. It sits in Kimber's Ascent Series and has been a reviewer favorite for many years. Like every Kimber cable, it is braided and terminated by hand in Ogden, Utah.

Four 19 AWG Copper Conductors in a Quadratic Braid

Each conductor is 19 AWG VariStrand copper, a bundle of strands in more than one gauge. The four are woven in what Kimber calls a quadratic braid. Kimber says the braid gives wide bandwidth and noise reduction without the use of shielding.

Virgin FEP Insulation and Hand-Soldered Ends

Kimber insulates each conductor with virgin FEP, a fluorocarbon it applies in single and dual layers. It publishes the result: 78 pF of capacitance, 0.385 µH of inductance and 0.037 ohms of resistance per meter. The plugs are soldered on by hand under nitrogen, which keeps the joint clean as it cools.

The WBT-0102 Cu Plug, Explained

Hero ends in the WBT-0102 Cu, a WBT Topline plug. It keeps WBT's nextgen design and adds a brass sleeve of higher conductivity on the ground side. WBT says that matters most for phono outputs. The contacts are pure oxygen-free copper. WBT rates it at 75 ohms to 200 MHz.

The body is brass under a barrel finished in black piano lacquer. The central contact sits in Ultramid and the ground contact in Dyneon, two low-loss plastics. WBT's collet clamp locks the plug onto the jack and takes cable up to 9 mm across.

What Reviewers Are Saying

The Absolute Sound staff, in the 2017 Editors' Choice list published April 6, 2017, wrote that "Hero's bass lives up to its name, prodigious in amplitude and definition."

Jason Kennedy, reviewing for hi-fi+ on January 17, 2018, found that "as soon as you drop it into the system the timing comes into focus." Stereophile’s 2026 Recommended Components calls Hero the "strong, silent type" among cables.

Who Is This Interconnect Best For?

• You want more than a three-wire cable gives — Kimber designed Hero's four-wire braid for wide bandwidth, so the whole range gets through
• Your sources sit near power supplies — the quadratic braid cancels induced noise along its length, so the shelf stays out of the music
• You value bass weight — The Absolute Sound singled out Hero's low end for its size and definition, so kick drums land
• You run a turntable — the WBT-0102 Cu's higher-conductivity ground sleeve is built for phono-level signals, so hum and pickup stay low
• Your components both offer XLR — Hero is single-ended RCA. If both your components have balanced XLR jacks, choose the Kimber Hero XLR instead. Or call us and we will match the connector

How Does It Connect to Your System?

Run Hero from a line-level output, a DAC, streamer, CD player or phono stage, to a line-level input on your amplifier or preamp. Keep left to left and right to right. Slide each WBT plug onto the jack, then turn the barrel to tighten the clamp. Loosen it before you pull the plug off.

Then listen. Other and longer lengths available. Call for prices.

Pairs Well With

An interconnect is one link in the chain. It usually joins these categories.

• Integrated Amplifiers — the usual input end
• Digital-to-Analog Converters — DAC output to amplifier
• Phono Preamplifiers — phono stage to line input
• Speaker Cables — the last link to the speakers

Frequently Asked Questions

What is the WBT-0102 Cu connector?

A WBT Topline RCA plug. It uses WBT's nextgen contact design with pure oxygen-free copper contacts, a higher-conductivity brass ground sleeve for shielding, a black lacquered brass barrel and a twist-to-lock collet clamp.

How does the WBT-0102 differ from WBT's other nextgen plugs?

WBT gives the 0102 a brass ground sleeve of higher conductivity for better shielding. Everything else follows the nextgen design of a single, low-mass signal conductor.

What does VariStrand mean?

Each conductor is made of strands in more than one gauge. Kimber uses this stranding in every interconnect it makes and says the mix of gauges spreads the signal across the bundle.

Is Hero shielded?

There is no separate shield. Kimber says the four-wire quadratic braid provides the noise reduction, which is why the cable has no outer jacket.

Why four conductors instead of three?

Hero has four 19 AWG conductors where Kimber's three-wire cables have three. Kimber says the four-wire quadratic braid provides wide bandwidth and noise reduction without shielding.

Is there a step up from Hero with WBT-0102 Cu plugs?

Kimber Silver Streak is the next rung. It moves to Kimber's Summit Series and adds a silver conductor to two copper ones.

See It in Action

Audio Advisor looks at the Hero braid and its plugs.

The balanced version of the same cable, for a look at how Kimber terminates it.

Why Audio Advisor?

• 40+ Years of Expertise — Since 1981, we've helped over a million music lovers find the right gear.
• 60-Day Money-Back Guarantee — Take your time. Listen, enjoy, and make sure it's right for you.
• Real Experts, Real Help — Our team is here to answer your questions at 800-942-0220, weekdays 9am–6pm EST.
• Free Shipping — On orders over $49, delivered to your door.
• Flexible Payment Options — Financing available so you can start listening now.

Learn More

Want to learn more about interconnects, braided cables, or RCA versus XLR? Visit our Learning Center for guides, tips, and expert advice.