Monitor Audio Silver 200 7G Floorstanding Speaker - Black Oak - Each

A Smaller Cabinet, the Same Point of Difference: A 2.5-Way Design

The Monitor Audio Silver 200 7G is a 2.5-way floorstanding tower from the seventh-generation Silver Series, built around a 1-inch C-CAM gold dome tweeter in a Uniform Dispersion Waveguide II, paired with two 5.25-inch C-CAM mid-bass drivers using Rigid Surface Technology II cones.

Monitor Audio rates sensitivity at 87.5 dB into a nominal 8 ohms, and recommends amplifiers between 60 and 150 watts — a modest, easy-to-drive load for a tower of this size and price.

The cabinet is available in Satin White, High Gloss Black, Black Oak, Natural Walnut, or Ash, and each tower is sold on its own, so a stereo pair means ordering two.

Where the Smaller Cabinet Still Delivers a Big-Tower Sound

One Tweeter, Two Mid-Bass Drivers: A 2.5-Way Design

The 1-inch C-CAM gold dome tweeter sits inside a Uniform Dispersion Waveguide II, crossing over to the mid-bass drivers at 2.7 kHz with unusually consistent off-axis dispersion for a tower this size.

Two 5.25-inch C-CAM drivers, built with Rigid Surface Technology II cones, share the work below the crossover: the upper driver covers mid-bass, while the lower driver, relieved of midrange duty, handles bass alone.

The Numbers, and What They Ask of Your Amplifier

Monitor Audio quotes an in-room frequency response of 34 Hz to 35 kHz, measured at -6dB, with a maximum SPL of 108 dB. Sensitivity is 87.5 dB, nominal impedance is 8 ohms (5.0 ohms minimum), and power handling is rated at 150 watts RMS.

The cabinet is rear-ported, and each tower ships with both carpet spikes and hard-floor rubber feet, so it settles onto either surface without an extra purchase or a trip back to the store.

Who Is This Floorstanding Speaker Best For?

• You want a genuine Monitor Audio Silver-Series tower in a smaller footprint — the same 2.5-way point-of-difference and C-CAM driver technology, scaled down for a tighter room
• You want a tower that arrives ready for either floor — both carpet spikes and hard-floor rubber feet ship in the box
• You want a real choice of finishes — five options, from painted Satin White and High Gloss Black to real Black Oak, Natural Walnut, and Ash veneers
• Your amplifier delivers a modest, honest wattage — 87.5 dB sensitivity into an 8-ohm load is a comfortable match for amplifiers between 60 and 150 watts
• You want real floorstanding bass without a separate subwoofer — the Silver 200 7G reaches to 34 Hz on its own. For the deepest home-theater effects, add one of our subwoofers and let the towers do what they do best

How Does It Connect to Your System?

Connect each tower to an amplifier or receiver's speaker outputs using the rear binding posts. An 8-ohm nominal load (5.0 ohms minimum) suits amplifiers rated between 60 and 150 watts.

Since the cabinet is rear-ported, leave a few inches of clearance behind each tower before settling on a final position.

Fit the carpet spikes or the hard-floor rubber feet, whichever suits your room, then connect: two cables, two speakers, and you are listening.

Pairs Well With

What finishes the system around a pair of Silver 200 7G towers:

• Integrated amplifiers — a comfortable match for this tower's 60-to-150-watt recommended range
• Stereo amplifiers — for even more headroom above the recommended range
• Speaker cables — connect to the rear binding posts
• Audio racks — house the electronics driving a genuine Silver-Series tower

Frequently Asked Questions

How much amplifier power do I need?

Monitor Audio recommends amplifiers between 60 and 150 watts. At 87.5 dB sensitivity into an 8-ohm load, most integrated amps and receivers in that range drive it comfortably.

What comes in the box?

Each tower ships with both carpet spikes and hard-floor rubber feet already fitted, along with the owner's manual, so it's ready for either surface.

How far from the wall should I place them?

Since the cabinet is rear-ported, give each tower some room behind it. Moving it closer to the wall adds bass warmth; pulling it out tightens and tames the low end.

What finishes are available?

Satin White, High Gloss Black, Black Oak, Natural Walnut, and Ash — covering both painted and real-wood-veneer looks.

Do I need a subwoofer with these speakers?

Not necessarily. The Silver 200 7G reaches to 34 Hz on its own, though a subwoofer can still add reach for home theater use.

See It in Action

Home Cinema King reviews and demonstrates the Monitor Audio Silver 200 7G.

Home Cinema King unboxes the Monitor Audio Silver 200 7G.

Why Audio Advisor?

• 40+ Years of Expertise — Since 1981, we've helped over a million music lovers find the right gear.
• 60-Day Money-Back Guarantee — Take your time. Listen, enjoy, and make sure it's right for you.
• Real Experts, Real Help — Our team is here to answer your questions at 800-942-0220, weekdays 9am–6pm EST.
• Free Shipping — On orders over $49, delivered to your door.
• Flexible Payment Options — Financing available so you can start listening now.

Learn More

Want to learn more about speaker placement, amplifier matching, or getting the most from a floorstanding tower? Visit our Learning Center for guides, tips, and expert advice.